PEM T-coupling female thread 50xR50x50

Our range of compression fittings are quick and easy to install in sewer & water distribution pipe systems. The range meets industry standards and regulations.

Plastic pipe coupling is intended for joining polyethylene pipes (PE80, PE100 and PE100RC) and PEX.

Pressure: 0-16 bar
Temperature: -10 °C to +45 °C
Material: Polypropylene
Seal material: NBR

Areas of use

– Underground and indoor drinking water pipes
– Underground service pipes
– Irrigation pipes
– Geothermal and ground heat collectors
– Optical sewerage
– Pressure sewers

Benefits and advantages

– Quick, safe and easy installation
– Coupling nut, grip and seal do not need to be removed when connecting pipes
– Pre-lubricated NBR sealing rings
– Optimum flow properties
– High grip force
– Long service life

Pressure class: PN16, Approval: ISO 17885

Compression fitting for PE and PEX pipes made of PP, clamping ring in POM, sealing ring in NBR.

Operating temperatures

The maximum operating temperature for couplings and valves is the same as for polyethylene pipes, about 45 degrees. They withstand freezing temperatures well.

Assembly instructions

1. Remove the blue nut and slide it over the pipe
2. Slide the white grip ring over the pipe and push it back from the pipe end
3. Make sure that the cut end of the pipe is clean. A chamfer can be formed on the pipe with tools and this makes it easier to fit the coupling
4. To facilitate installation, a silicone gel can be applied to the end of the pipe and the O-ring
5. Push the tube inside the coupling. The pipe stops when it touches the O-ring
6. Now press again and you will feel the pipe sliding over the O-ring. The pipe will slide beyond the O-ring by between 12 and 20 mm depending on the size of the coupling used
7. Slide the white grip fitting up to the fitting
8. Pull down the blue nut and tighten the coupling. Tighten the fitting by hand and now continue to tighten the blue nut with a few grips. Do not overtighten the coupling

No files available.