Baga Efficient 4m3 package biomodule 2 households

Shipping will be added, see shipping price at checkout or pick up from us in Västerås at no extra cost.

Infiltration area with Baga Biomodules 32m2

Size
Diameter 2200
Height 2150mm
Weight 238kg

Inlet VG 1315mm
Connection 110mm

Outlet VG 1215mm
Connection 110mm

Volumes
Total volume: 5.8m3
Wet volume: 4m3
Sludge volume: 2.8m3

Convertible to Baga Easy treatment plant
(has double sludge capacity and can therefore handle chemical precipitation of phosphorus)

The spreader plates replace the upper macadam layer in the infiltration/
soil bed, thus saving large amounts of gravel material and transportation costs.

For infiltration where the soil has good infiltration properties, the spreader plates can be laid directly on the underlying loosened soil layer in the bed, without any macadam or sand. For reinforced infiltration, 30 cm of soil bed sand is added.
– Low-build installations
– Save large amounts of material
– Less work and greatly reduced costs
– Guarantees that really matter

BAGA sludge separators are by far the most efficient sludge separators on the market. Tests at SP (Swedish Technical Research Institute) have shown unique results. It has not been possible to measure any sludge escape of particle-bound pollutants! The design of BAGA sludge separators, with a high oxygen supply and large volume, provides a significantly better purification effect than a conventional 3-chamber well.

Size: 2000x2100mm
Wet volume: 4m3
Sludge volume: 3m3

100% particle separation
BAGA sludge separator is the only one so far that has the ability to completely separate particles from wastewater according to tests. Tests (EN 12566-1) performed by SP (Swedish Technical Research Institute) show unique results, zero particle emissions in five repeated measurements, see table.

Particle-bound pollutants are thus separated to a significantly higher degree than in a conventional sludge separator. This extends the life of the subsequent infiltration, or soil bed, and increases the degree of purification.

NEW!
Installation area 16m² (2x8m)
1st biomodule package with spreader plates

BAGA biomodules are advantageously used in individual sewage plants where a traditional soil or infiltration bed is to be constructed, at a normal level of protection. The modules are also a good solution for installations with a high level of protection when a sewage system (BAGA Easy) with a bed
is to be built.
The function of the biomodule is to improve the oxygenation of the bacterial culture that reduces pollutants in the household’s
wastewater (i.e. water from bath, shower, washing, dishes and toilet).

Meets the requirements by far
A bed with BAGA biomodules built according to the instructions meets the requirements set by the authorities for a high level of protection for health protection, and a normal level of protection
for environmental protection.
The water that has passed through our modules is hygienized and the levels of pathogenic bacteria are far below the guideline values.

With the biomodule package and spreader plates you can remove the macadam in the spreader layer
An example is the soil bed:
Old building height of the bed was 130 cm
Now the building height will be 55 cm high

To build a soil bed, the infiltration must be supplemented with drainage pipes or dense fabric if it is to be a dense soil bed.

Consists of :
Sludge separator 2 households
2 biomodule packages