AC deep well pump 3″, 3Z18, 0.55KW, 230Volt

Fits boreholes of max. approx. 30 meters deep

Dimension max. pressure (head) required by the pump
Pressure at the tap (max. pressure): 3 bar = 30 meters
Pressure loss from friction in pipes and couplings: approx. 5 meters
Static head (lowest level of the water surface in the well to the top tapping point) = meters

The sum of the heights must always be lower than the maximum lifting height by far.

The pump diameter is 75mm and requires at least 85mm inner diameter of the casing

An advantage of this pump is that it can be easily separated into two parts, the electric motor and the pump part.
This means that if the pump’s electric motor or pump part breaks down, you can just replace that part and save money.

Those who have bad water that wears out the pump part a lot can have one in reserve at home for quick replacement at lower cost.

Submersible pump 3Z with1-phase or 3-phase from the manufacturer Omnigena, is a 3″ multistage pump for pumping clean and cold water.

The pump can be used in a wide range of applications, both at home and in the industrial, agricultural and horticultural sectors.

The device can be used to operate water supply systems, irrigation systems and irrigation.

There is a valve inside the pump, but this is not a check valve but an anti-sand return valve and protects the hydraulic part from returning sand from the pipeline.

May need to be purchased for

• Pem slang
• Drill cap, cover for the borehole to protect against contamination
• Lifting cables and clamps
• Single adapter for connecting the pump to the feed pipe

The length of the pump cable included is 20 meters unless you buy a pre-spliced power cable.

Select if you want a pre-spliced drinking water approved power cable in the most common length above the buy button.

If other lengths are desired, it can be ordered against longer delivery time.

Technical data
Max capacity: 110 l/min.
Max lifting height: 62 m.
Motor power: 0.55 kW.
Voltage: 230V.
Outlet: Female thread R40 (1/2″)
Pump diameter: 75 mm
Weight 13.4 kg, without cable

Max water temperature: 35°C.
Degree of protection: IP 68.
Winding insulation class: B.
Number of starts up to [x/hour]: 20.
Minimum cooling flow for the motor: 0.08 m/s.
Working position: vertical.

Materials:
Pump casing: stainless steel.
Cable sheath: stainless steel.
Pump shaft: stainless steel.
Impellers and diffusers: noryl.
Inlet strainer: stainless steel.
Outlet: brass.
Suction body: brass.