Divertron 900 Universal pump

Submersible universal pump, multi-stage with integrated start/stop, check valve and dry run protection.
The pump is for clean water

Field of application
Irrigation, Own water, Excavated wells.

Design
Multistage, submersible pump with 4 impellers. Built-in non-return valve.
The pump has a built-in start and stop function that starts the pump at 2.2 bar and stops at the pump’s maximum pressure.

The pump comes with 15 meters of electric cable.

Max immersion depth 15 meters. Voltage 1x230V / 50 Hz.

Built-in thermal motor protection.

Working temperature: 0°C/+40°C.

RSK number 5854009

Design
Multi-stage, submersible pump with 3 impellers and built-in check valve. The pump has an integrated start and stop function that starts the pump at 2.4 bar. The pump stops with a delay of 10 seconds after the flow has stopped and the pressure is above the starting pressure. The pump is supplied with 15 meters of electric cable. Voltage 1x230V / 50 Hz. max immersion depth 12 meters. Built-in thermal motor protection. max 20 starts per hour.

Material specification
Impeller Plastic Technopolymer
Impeller Plastic Technopolymer/Stainless steel
Diffuser Plastic Technopolymer
Motor shaft Stainless steel AISI 416
Impeller shaft Stainless steel AISI 303
Gaskets EPDm
Shaft seal Carbon(resin treated)/Ceramic/NBR
Filter mesh suction Plastic Technopolymer

TECHNICAL DATA
Flow rate: from 1 m3/h to 6 m3/h
Lifting height up to: 45 m
Maximum working depth: 12 m
Type of liquid pumped: clean, free of solids or abrasives, non-viscous, non-aggressive, non-crystallized and chemically neutral
Liquid temperature range: from 0°C to +40°C
Maximum immersion depth: 15 m
Connection, thread: 1″ (supplied as standard with a four-section coupling reducer )
Maximum pump diameter: 160 mm
Impeller/s material: technopolymer
Maximum number of starts: 20/h
Protection class: IP 68
Motor insulation class: F
Single phase power input: 230 V 50 Hz
Power cable (m) and plug: 15 m H07RNF with mains plug
Possible type of installation: fixed or movable in vertical position

New Diverton
The first generation of Divertron was developed in 2007 and broke into the market as a complete novelty: it is a range of submersible pumps with integrated on/off electronics, a feature that has made it a product of excellence to this day.

After 15 years and after more than 1 million units installed. DAB’s ongoing research and drive for continuous development has led it to launch the second generation of Divertron.

This product has been improved in terms of appearance and technical and technological content to increase its performance and reduce its consumption, adapting it in good time to the next MEI regulations on energy efficiency.

At the same time, it has been made even stronger and easier to install and maintain.