AC OMNIGENA WQ 1100F VORTEX PUMP 230V

As this is a vortex pump, it does not chew the contents into a thin gruel and is suitable for pumping to a sludge separator or treatment plant.

Note this pump requires 50mm PEM hose if you are going to have it to drain with toilet water.

The WQ 1100F submersible pump with a single-phase (230V) Omnigen motor can be used to pump out dirty and contaminated water from sewage systems, flooded rooms, swimming pools and ponds.

The maximum diameter allowed for impurities is 35 mm.

The construction of the WQ 1100F pump is made of stainless steel and cast iron, thanks to which it is resistant to corrosion and wear.Such a solid construction is a guarantee of a long service life of the unit.

The WQ 1100F pump runs automatically. The built-in control float controls the water level at a given location and then starts or stops the unit. The water level at which the pump starts and stops can be adjusted by shortening or lengthening the hose between the pump and the float light. The float regulator is also a protection against dry running.

Despite the high engine power, the pump generates little noise and does not consume large amounts of electricity.
It is very efficient. It pumps up to 430 liters of water per minute and lifts the liquid to a height of 12 meters

The pump is equipped with a power cable with motor protection and a plug with a length of 5.3 meters.

Motor protection included
We always recommend using the included overload protection to protect the pump motor.
One of the most common causes is blockage of the impeller which almost always ends up destroying the motor.
This protection should be installed in a dry place, not necessarily inside the building, but it cannot be exposed to moisture.
You can always disconnect the overload protection from the cable, extend the cable or install the overload protection in another safe place.

Cord length between pump and motor cover 500cm, cord length between motor cover and plug 30cm

Technical data