AC AUTOMATIC PUMP MH 1300 INOX PREMIUM 50L TANK

A high-quality drinking water pumping machine, which is quieter than others on the market and very popular with our customers.

This pump runs much quieter, standing completely still when the engine is running, unlike the most common automatic pumps on the market.

It is faster to pump up the pressure and gives better flow in our own tests at the Sewage Center.

The MH 1300 Inox Premium pump has a single-phase motor and can be used for drinking water to supply water to residential buildings, farms, industrial enterprises, etc.

The pump’s solid construction is resistant to mechanical damage and corrosion.

The pump casing, shaft and impeller are made of stainless steel.

The MH 1300 pumps are exceptionally quiet (75 dB.) compared to other pumping machines on the market.

Depending on the application, the minimum capacity of the tank should be 24 liters for holiday homes and for irrigation systems and 50 to 100 liters for water systems for a normal villa.

Technical data:
Max water temperature: 35°C
Protection IP: 44

Dimensions:
A. 64.5 cm
B. 59 cm
C. 65 cm
D. 39 cm
E. 37 cm

Materials
– Pump shaft: stainless steel
– Impeller: stainless steel
– Pump housing: stainless steel
– Suction body: stainless steel

For proper operation of the pump dispenser, you need a water inlet with an intake located closer than 8 meters vertically from the place where the pump is installed.

In addition, the horizontal distance of the pump from the water source should be considered.

Suction hose should be at least 25 mm (1”) or (1¼” ) 32mm for good performance.

Package includes

• MH 1300 Inox Premium
• membrane tank with a capacity of 50L
• Pressure switch
• Pressure gauge
• cable with plug

Technical data
Maximum capacity: 100 l/min
Maximum lifting height: 50 m
Maximum pressure: 5 bar
Motor power: 1,45 kW
Voltage: 230V
Outlet port: 1”
Max water temperature: 35°C
Degree of protection: IP 44
Factory pressure in the tank: 1,5 Bar
Pressure side connection: R25 1” female thread
Suction side connection: R25 1” female thread

Materials
Pump shaft: stainless steel
Impeller: stainless steel
Thrust body: stainless steel
Suction body: stainless steel
Diffuser and guide: noryl
Tank: Steel
Diaphragm in tank: EPDM
Tank covered with anti-corrosion paint

Installation and operating instructions:
At first start-up, fill the pump body and suction pipe with water, then the pump itself will create a negative pressure to facilitate the suction of water from the source.

A non-return valve is required for the suction system to work properly. It prevents water from flowing back to the source after the pump has stopped. The water left in the system allows the pump to start again without the need to refill the system with water.

The first start-up of the pump must be done with free flow of water from the system to pump out air particles from the suction system. For example, open valves or taps. If no more air comes out with the pumped water, the pressure switch can be adjusted.

No pump can run dry, they must always have water in the pump housing when starting!