AC Pumping station 75cm Vortex pump 1-phase

As this is a vortex pump, it does not chew the contents into a thin gruel and is suitable for pumping to a sludge separator or treatment plant.

Note this pump requires 50mm PEM hose if you are going to have it to drain with toilet water.
Our new bestseller!

Complete ready-to-install pumping station with piping system including check valve and single adapter. Self-cleaning sump.

Size well
AC villa pumping stations are available in different heights and can easily be cut to the desired height.

• AC villa 175 can be adjusted from 145 to 175cm
• AC villa 245 can be adjusted from 175 to 245cm
• AC villa 345 can be adjusted from 245 to 345cm

Diameter inside: 600mm diameter outside: 700mm

Lid:
Lid with insulation board to withstand freezing temperatures.
The lid can withstand loads of 150 kg

Connections

Outlet: R50 (2″) female thread, 430mm cc from bottom
Inlet: 110mm, 500mm cc from bottom (installed on delivery)

Quality pump
The WQ 1100F submersible pump with a single-phase (230V) Omnigen motor can be used to pump wastewater with WC.
The permissible diameter for impurities is max 35 mm.

The construction of the WQ 1100F pump is made of stainless steel and cast iron.

The WQ 1100F pump runs automatically. The built-in level rocker starts or stops the pump.
The water level at which the pump starts and stops can be adjusted by shortening or lengthening the cable to the float rocker.

Despite the high engine power, the pump generates little noise and does not consume large amounts of electricity.
It is very efficient. It pumps up to 430 liters of water per minute and lifts the liquid to a height of 12 meters

The WQ 1100F pump is equipped with a power cable with motor protection and a plug with a length of 5.3 meters.

Motor protection included
We always recommend using the included overload protection to protect the pump motor.
One of the most common causes is blockage of the impeller which almost always ends up destroying the motor.
This protection should be installed in a dry place, not necessarily inside the building, but it cannot be exposed to moisture.
You can always disconnect the overload protection from the cable, extend the cable or install the overload protection in another safe place.

Cord length between pump and motor cover 500cm, cord length between motor cover and plug 30cm

Pump volumes
Since the well is so low, it is not possible to change the pump volume much, but it is about 50 liters.

Recommended PEM hose size is at least 50 mm

Technical data