Aquatron UV well 245

Aquatron’s UV well is the only UV technology that can safely handle water with particles, for example after a sewage treatment plant that often has sludge during malfunctions.

Aquatron’s UV unit is used to purify wastewater from bacteria and as a replacement for backwashing to many treatment plants

Aquatron’s UV unit utilizes both the water’s screw movement caused by the Meander effect and the threshold effect (all particles spin around and are illuminated on all sides several times), which means that even suspended water is fully exposed and a very good bactericidal effect is achieved.
To verify the worst case diarrhea condition, a test with diarrhea in three liters of flush water was made and the sample was taken immediately after the UV irradiation.
The analysis shows that the effect is virtually 100% bactericidal.

One advantage of the Aquatron UV unit is that the liquid never touches the UV lamp, which means that the effect does not deteriorate quickly like some other UV systems on the market.

– Alarm and readiness for malfunctions.
Aquatron UV is equipped with an alarm function that alarms if a UV lamp
should break. The unit is equipped with 2 UV lamps, which guarantees that full
purification is obtained even if one lamp should go out!

– Tested by SP independent party

UV tested by independent third party by SP Technical Research Institute of Sweden
, see table for summarized results.

Dimensions:
Model 175
Height: 60-175 cm

Model 245
Height: 60-245 cm

Diameter:
Inner tube: 59cm
Outer tube: 69cm
Lid 80cm

Inlet:
50mm, VG 255mm ±10mm

Outlet:
110mm, VG 50mm ±5mm
(If VG on inlet and outlet is important and crucial, contact us)

The UV unit can handle 468 liters/hour, 7.8 liters/minute and 11,000 l/day

If you have momentary higher flows, you can reduce the flow to the UV well with an equalization well or larger pipes that act as a water reservoir before the inlet of the UV well, which is limited by a 50mm inlet.